Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, I´m trying to connect my sip cube with AT&T flex reach service, but I can´t. when a incomming call arrive my phone rings but inmediatly call ended and rings again and stay ringing and call ended LOT. this is a log from a incoming call from p...
Hi, I´m doing a new implementation with hreap, i have 2 WLC 5508, in the HQ i have one SSID with l2 security wpa+wpa2 with AES and 802.1X, i configured the same ssid to remote location and i associated that ssid with a hreap group and an access point...
Jul 16 11:26:10.411: %RSP-3-SLAVECHANGE: Slave changed state from Slave to Non-participantJul 16 11:26:15.719: %RSP-3-SLAVECHANGE: Slave changed state from Non-participant to SlaveJul 16 11:26:16.135: %RSP-3-SLAVECHANGE: Slave changed state from Slav...
Hello, I'am Carlos, I'am from Venezuela and my english is not very good, but i need your help. The problem is that i have a cisco WS-C6506 with this configuration:interface Vlan1 ip address 161.196.136.129 255.255.255.128 secondary ip address 161.196...
Hi Dennnis,
Thanks, I have this config:
CUCM 10.5 (10.150.16.5) -- (trunk sip)-- CUBE--AT&T(Flex Reach)
In cucm I have a Device Pool with a MRGL (MTP software), my region (U2) use preference list with this order: G729a 8k, g729b 8k, g729ab 8k, g72...
OK, i´m agree, but i tried with a single ssid and configured this ssid like hreap at same time but then the hreap AP broadcast this ssid but the users could not authenticate, i am not sure if is correct config a single SSID for use in the central Of...
Hello, Thanks you, Yesterday I was checking the problem and discovered that the problem were a firewall, the ip address 161.196.204.1 was aditioned and the problem was resolved.Thanks
