Hi.  We have plenty of SUP 5 deployed throughout our sites (200+) and wanted to find out what ISE features are supported for SUP 5? on the ISE 2.x compatibility list, I only see SUP 6 or higher.  Nothing is mentioned about SUP 5.  What I need to find out is what feature of ISE is supported on SUP 5? We are planning to do dot1x, mab, profiling, and posture in future.  So I need to find out what is supported and what not.  Please provide URL or documentation so that I can present it to my customers.  Thanks, ... View more

Hi.  I have bunch of 2960G-8TC-L and 2960G-24TC-L switches.  ISE 2.x compatibility guide does not list the 2960G in there.  http://www.cisco.com/c/en/us/td/docs/security/ise/2-0/compatibility/ise_sdt.html#pgfId-198199 So I just want to find out if these are supported?  Are these the one that listed as 2960 Lan based? If supported, what features are supported?  Are all the below supported? AAA Profiling BYOD Guest Posture MDM TrustSec Thanks, Thomas ... View more

Hi all Cisco Guru, I have a customer who has 4402 controller trying to migrate to 5508 controller.  Is the license transferable? Someone mentioned that they have different pricing model, thus the license cannot be transferred.  I just need confirmation as to whether this is possible or not.   Any URL that I can see to find more information about?   Thanks,     ... View more

Good Morning, sir   I have a question regarding bgp route preference.  We have multi-homed BGP on remote site.  Let's call this site , site_a has verizon and at&t MPLS connection using bgp.    Currently, at&t route is preferred using as path prepend method.  We have addition AS number prepended on link to Verizon to prefer at&t route.    At this time, verizon is idle and not being used.  We would like to utilize this network to pass backup traffic.  We have source and destination address that we would like to pass through Verizon (out backup) link.    Any idea how I can do this?  I created the source/destination with ACL and created route-map matching that ACL and tweaked the local preference.  and since only major route is listed under 'show ip bgp' and not the specific route which I would like to influence,  I didn't see the tweaked route on routing table.    Any idea, anyone?    Thanks ... View more

Hi.   We have two Nexus 5K in vPC mode with 2 2248Fex uplinked to both 5K and configued as vpc there as well.   Recently we had power outage and pair of Nexus 5k that was in vPC configuration both rebooted. For some reason, the primary never came back up while the secondary came up fine.   When running the "show vpc role" showed the secondary as "not established" and the fex uplinks were down.   I would like to find out if there is any command under vpc to bring up fex ports even the vPC pair is not yet established possibly to prevent this from happening again.   Thank you ... View more

Good Day. I will be performing 4500 non-E chassis to 4500E chassis upgrade this week. non-E chassis has IOS 12.2 running on it while 4500E will have IOS-XE 3.2.5SG code running. Is there any website where I can paste the IOS configuration to see if they are compatible on IOS XE code? Thank you, sir. ... View more

Hi. Is EVN supported on Sup 7E on 4500 running enterprise image? Also for 6500, it's SUP2T. I see for 4500 on 3.4 image, EVN trunk is supported. Does that mean EVN is fully supported on 4500? Thanks                   ... View more