Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to get the the boot image installed on an ASA5515-X and it appears to hang at this portion of the installation and never finishes the recoveryMod-sfr 797> Starting OpenBSD Secure Shell server: sshd Here is the complete debug (200) output Mod-...
I have a customer who wants to upgraded the ASA to 8.4.7(15) they are currently running 8.2.5(41), The customer wants to run the 8.4.7(15) code for a few days before rebooting the 8.2.5(41) ASA to get the upgrade, has anybody had any issues with r...
We have a customer with a pair of ASA 5585-x in failover mode. They are looking to install a pair of IPS modules in these ASA's.Is there a way to install the IPS modules without any downtime. I know for failover the ASA's have to have the same hard...
We have upgraded our M660 to 7.2.1-036 code, we have not upgraded any of our WSA's to 7.x code yet, but noticed under the 7.2 configuration master that identities that had any identity that had a authentication realm/scheme are showing red and it's r...
You can have to different versions, see syslog messages below, I know if you run 8.2 and 8.4 you get the 103007 message, and it could lead to stability issues. So I was checking to see if anybody has run these 2 versions for a couple days and if the...
Just create differant object names using the same host ip address and add the nat to each of the object namesobject network obj-192.168.10.1-5501 host 192.168.10.1 nat (inside,outside) static interface service tcp 5501 5501object network obj-192....
