Hi voyo ,
I was suspecting PC performance , whenever i am using Sasd as it shoots to 100% utilization , one test i will do is i will assign single camera to a view and check the performance .
My laptop is 16 gb ram with core i7 2Ghz processor i suppose there should be no issue using this one.
Awaiting your valued input on this.
... View more
Thanks for your response.
Yes previously there was issue for recorded video and because the live video feeds from camera were using a template with low bandwidth etc settings but since the video quality was very poor i changed to Medium and High . I also tried manual settings by defining custom templates but the problem severs with HD.
I have tried a number of machines for Sasd and the result is not satisfactory with any one
... View more
There are two models of camera ie 6400E which supports HD and 2835 SD PTZ.
For 6400E i am selecting NTSC video format with H.264 , bitrate 4Mb , fps 30
For 2835 PAL H.264 bitrate 2Mb fps 25
I have tried even using low parameters but still not acceptable.
Appreciate your input.
... View more
Hi ,
Sorry for updating too late on this thread.
The problem persists with live and recorded videos both.
The setup is a small campus with VSOM on physical ucs from cisco , links between camera and switch is 100Mb and Server is on 1Gb link. VSOM 7.5 is running , i tried generic and manual templates but no improvement . If i add camera with low bandwidth settings the video is smooth but quality is not acceptable. However when i add HD or Medium bandwidth the video plays with 1 sec pause continuasly. I am using SASD to view the camera.
Tried changing almost all parameters but no success. There is no alarm or mediaout drops on the server and on the switch ports.
... View more
Hi ,
Sorry for updating too late on this thread.
The problem persists with live and recorded videos both.
The setup is a small campus with VSOM on physical ucs from cisco , links between camera and switch is 100Mb and Server is on 1Gb link. VSOM 7.5 is running , i tried generic and manual templates but no improvement . If i add camera with low bandwidth settings the video is smooth but quality is not acceptable. However when i add HD or Medium bandwidth the video plays with 1 sec pause continuasly.
Tried changing almost all parameters but no success. There is no alarm or mediaout drops on the server and on the switch ports.
... View more
Hi ,
I have vsom 7 new installation , everything seems fine for live video . But for recorded video when it plays it plays with delay. like 1 second it moves and 1 second stops.Suppose if a car is moving it is shown as moving in steps.
Any help please.
... View more
Hello,
Cisco PI 3.1 chassis view is missing for a number of devices such as 4500x, 6500E and some other models , even with the device pack 10 installed.
Is something wrong with my server or these has not been provisioned yet.
Regards,
Farooq
... View more
Hello,
Is there a recommended procedure for upgrading the Cisco ios on stacked switches from Cisco Prime ? I tried on Cisco 2960S and the ios gets updated only for Master switch , resulting in Stack breaking due to ios mismatch.
Regards,
Farooq
... View more
Thanks Marce for reply,
I tried the procedure on two server, the secondry server has successfuly completed all the steps.
But the primary C220 is not accepting F6 to go into setup.I tried a number of times.
... View more
Hi ,
Can anybody please guide me to a link for the above activity.How can we delete the existing files from the disks to make a fresh reinstall.
How to optimise the server as the application performance is slow.
Regards,
... View more
Hi ,
Can you please paste snapshots or guide me about captive portal settings in packetfence.There is very little about the captive portal settings in the guides.
... View more