Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I have cisco 2911 voice supported routerI have 2 FXO ports on which I have connected 2 lines and I am planning to make a PSTN call using my Cisco IP phoneI tried with MGCP but due to caller ID issue, I am now planning to go for H.323.Can any ...
Hello Folks,We have IM&Presence 10.5 I have Publisher and subcriberI have LDAP sync users.But I am obsvering few users are in primary node and few users are in secondary node.I wanted to bring all the users in primary server is there any option to ma...
Hi Folks, When i run show isdn status it says layer 1 deactivated I am trying to make e1 controller up (Cisco 2911)Licenses seeems to be fine,PVDM card is installed ,in show diag I can see my cards installedI have checked my all configuration and see...
Hi all, Could any one please help me with a guide or a link,PDF,matrix sheet or master data which will provide me below details.1. Complete details of Voice supported router models.2. List of IOS versions for running voice base services,types of Lice...
Please help !!! Using this IP phone I wanted to make a PSTN call and for incoming call my PLAR will be 450001and voice port is 0/0/1 to which the FXO line is connected. Please help me with dial-peer config also to make outbound and inbound calls
Guys I undertsand that its a vague statement interms of Router which can be used for multiple things like CME,PSTN for CUBE, unity express etc when it comes to voice networks.However It becomes bit dificult to browse through cisco sites to look for...