Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with a Nexus 9372PX not responding to pings of the HSRP address it is a participant in.Topology2 x 9372 connected in vPC domain 11connected to2 x 9372 connected in vPC domain 21The HSRP address is across all chassis, so we have a ...
Hi,Configured a new context with the GUI, deployed it and the ACE reloaded and entered initial configuration mode! The peer device took over, a restore all was performed and the ACE became primary once more, the peer is now in standby cold.A show ver...
Hi,I am trying to configure a 887VA-M utilizing the autoinstall feature, however the 887VA-M doesnt appear to be making any attempt to get a DHCP address when it boots. There is no startup configuration present.Does the 887VA-M support autoinstall fr...
Hi,I have some error messages in the Nexus 7000 log, after searching i cannot find an adequate explanation, pretty much the only thing i can find is below and i don’t think it is very relevant to my situation. The device is in production and so reloa...
Hi,I have an issue with sticky server that I’m hope might just be a command I’m missing. I am inserting a cookie and the sticky works fine. When my browser has a successful sticky connection i take the server that has the sticky connection out of ser...
Steve,Apologies i led you up a garden path with the TTL, the switches are not configured with 192.168 addressing so I've been altering stuff before cut and pasting, i was using the pings to illustrate the increase in response time, i didn't pay atte...
Steve,Thanks for the reply, with regard to ethanayler I was greping for icmp, looking for pings from the same interface that also has the hsrp address, so from 192.168.1.2 to 192.168.1.1.interface Vlan101 ip address 192.168.1.2/24 hsrp version 2 h...
Below is pretty much the issue experienced, but i am also suffering low ping responce to all IPs on the box as if the control plane is shaping but i cant find any command outputs to support that.https://tools.cisco.com/bugsearch/bug/CSCuq09078
Hi OleksandrThanks for the reply, apart from the log message i cant find any other command that displays to me the CRC errors, do you know of any other commands i can run to view the "impact" of this error. I would like to collate more evidence befo...
