Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
is it possible to import a pre-created list of URL/IP addresses updated by security operations on an automated basis into a configured URL category list?
1. On the limited CLI, the best I can think of is to do an expect loadconfig on a single ...
Hello,I'm wondering if there is any API to deploy configuration updates/changes to the ESA and an API to retrieve custom data from the ESA/SMA?After looking around my first impression is...There is no API for configuration updates/changes and my best...
Hello,can one generate reports by defined identities?User reports typically include AD user names or an ip address. Can one generate a report for networks or better yet a number of networks that in consequence form an identity, i.e. to generate repor...
Hi,i want to dial out of Outlook and various other applications. This works in general but i encountera problem with the interdigit timeout (default 15 sec).When i dial a contact, which is identified as an external user by a leading '0', the telephon...
Hi Tom,
I haven't tested this but the manual states:
"The Web Security appliance uses a regular expression syntax that differs slightly from the regular expression syntax used by other Velocity pattern-matching engine implementations. Further, the ap...
Hi,we had 100% the same problem with the application missmatch in a new setup with the same version.Cisco provided a CLI command to initialize the the updates again. This wasn't working. To cut the story short, it was fixed by cisco support technicia...
Unfortunatly the Management Appliance doesn't offer any other settings then the WSAs themself.I may have to give Splunk or Sawmill a try then.CheersChristoph
