Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Andy,The common configuration for this type of scenario is to bridge the VLAN1 and Dot11radio interfaces together in order to place both wired and wireless clients on the same VLAN/network. If the customer's requirement is to allow both static WE...
Hi Adrian,The debugs I suggested may contain information you may not want to post on the forum, so use your discretion. The ACS logs should help identify whether the clients are actually hitting the server. As long as you have your switch configure...
Hi Jack,My original post was correct. The moderator of the forum edited my post to remove the bogus passwords. Unfortunately, they also removed the preceding '7' and '0'. It's a safety precaution cisco.com uses to keep inadvertant posting of real ...
Hi Adrian,Please try to capture output of the following while attempting to associate to the secure ssid:debug radiusdebug aaa authenticationdebug dot11 aaa auth allAlso, if you check your RADIUS failed attempts log, do you see anything?I don't see a...
Hi,Can you post your controller config ('show run-config')? Also, it appears the AP is in the same VLAN as the controller, so if they are on the same switch, can you post the switchport configs for each device (controller and AP)?Thanks,Ben
