Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
MWAM in 7613 is reported as unknown in DFM.7613 is known to DFM and i am getting traps (events, and alerts).CM discovered mwam.RME is getting syslog-s from mwam.Inventory Change reports are working OK.CiscoView shows mwam on chassis picture.Is this s...
Hi,what about management and ap-manager on same VLAN on 5508?Did you receive any error message or warning when you configured ap-manager on same VLAN as management interface on 5508?Regarding failover, there is a note in conf guide 6.0"For 5500 serie...
Hi,You can use Leap and Peap (and others) both with wpa on the same AP (same SSID, same VLAN) if you have auth. sever(s) that support them. dot11 ssid ittest vlan 100 authentication open eap peap_list (for 3rd party clients ...) authentication...
Hm, tried re-adding, device is still unknown.Device removed from dcr, tis logs shows deleting of device from dfm. Also, found logs for adding to dfm ... (sync with dcr)... , sysObjectID is problem.This mwam is recognized as sysObjectID:Cisco MWAM (1....
