Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,From the symptom it seems to be software issue. Fix is available in 6.2(14), 7.2(x), and later. Workaround:While system can operate with only one flash device, its highly recommended to recover and add the removed flash back into RAID configu...
Hello,Invalid cksum and isolated bad blocks in NVRAM may be logged in Supervisor-1s running 6.1code. In the occurrence of a single NVRAM block failure the issue can be cleared up by areload of the affected supervisor. However, if multiple test failur...
Hello Ken,Greetings! Yes, it is very much possible the link bandwidth getting maxed out, utilization reaching 100%. You can take following steps to isolate the issue:-- Check the interface utilization. You might need to take a Wireshark capture to i...
Hello Muhammad,Greetings! The messages you're seeing do not indicate a test failure, they're merelyinformational messages stating that the test got skipped due to high inbandport or CPU utilization. If this utilization is above a certain thresholdth...
Hello,Kindly find the answer inline: -- Adding an additional supervisor (w/c will be in Active-Standby) is simply opening a slot and inserting the 2nd one - See more at: https://supportforums.cisco.com/discussion/12339266/redundant-supervisors-what-d...
