Hi Rob,The thing is we are migrating from WCS to Prime. And now we have done everything except the m...

Hi all,I have a really specific problem with exporting maps from WCS to Cisco PI 1.3. Here is the pr...

Hi,Installation should be pretty straightforward. Since it is running on supported platform.ade # un...

Issue has been resolved by TAC. Our access points (LWAPP and Standalone / Autonomous) were converted...

Hi,Mind explaining relevant configuration parts of Prime and ACS.Regards,P.

Hi,Since it is a virtual appliance just attach them show tech-support and this should be sufficient ...

Exchange works perfectly, you must verify the configuration of your mailserver how the user should p...

I have similar requirement. I am working on this, I will let you know the result within the next few...

Apparently just by doing "Sync" device its working perfectly.Predrag Petrovic

That's strange, usually you would get debug output when you initialize interesting traffic. I will l...

Also if you dont mind post the debug outputs from debug crypto isakmp and debug crypto ipsec (santiz...

Hi all,Since I have some huge amount of static routes I want to start replacing them with OSPF or EI...

I want to create some basic alarms on our infrastructure. I want to monitor only specific ports on s...

I am running 1.3, I was running 1.2 for two days only until I faced issues with WCS and Autonomous A...