Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys. I am in the process of designing a network for a 16 floor building. The network is going to Include around 400 IP Cameras- all POE or UPOE going back to a central location. Everything is going to be Multicasting. My questions are: What sw...
I have a packet tracer lab that i am using to learn my CCNA on. I have 2 sites connected together by layer 3 switches and i cannot ping between the sites. The trunk is vlan10 with addresses on each side of 1.1.1.1/30 and 1.1.1.2/30From each switch i...
Hi Guys, I am trying to configure my lab with Vlans and access to the internet VIA my Virgin Media router. I have had this working but while messing around i have broken it. Can anyone give me a hint as to how? Below is my router configuration. M...
Hi Guys, I am curreltly studying for my CCNA and although I believe I have everything set up more or less correctly, My network throughput out to the internet is Very slow (0.06mbps) when running through my test network. Directly through my home ga...
So i am studying for my CCNA and i have a problem getting a serial link to work. I have tried 2 cables and re-seating the serial module. Have i done something wrong or is it broken? I have switched loopback on both side and the line protocol doesnt...
I am looking at stacked 3750 for my core on levels 1,2 and 14 all connected with 10G uplink as my core. For individual floors either a 2960 on each floor or 3750 per 3 floors- Going either up or down to the nearest stackThere is the potential for ne...
Hmm. I was reading this:http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/data_sheet_c78-584733.htmlI though I was ok with dual 1100w Power then I could have complete UPOE.I better check do some extra reading ...
I think we need to look at UPoE as some are likely to be heated cameras. For those floors i was thinking of stacking 3x 3750x with dual 1100w power supplies. on floors 1,2 and 14 That should provide the 50w per camera needed with the cameras connect...
Ok, More information. All switches need to be POE and support Mulitcasting and 10/100/1000 There will be 8 floors with 3 cameras on each floor. (Although need to allow for up to 6 per floor) Do you know of a suitable POE switch? I was considering...
I don't have the drawings in front of me so its a job for tomorrow. I can probably get away with single 24 ports for most floors. The 2 big floors are going to have around 60 cameras on each. One will need to be POE+ for internal cameras and acces...
