Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
We have noticed that ‘basic’ configuration of auto smartport on IOS 15.2 won’t apply CISCO_SWITCH_EVENT (it does on IOS 12.2(55) ).
Lab setup:
[WS-C2960X-24PSQ-L, 15.2(3)E1] int Gi0/25
|
[WS-C3560-8PC, 12.2(55)SE9] int Gi0/1
See...
Hello!
We rehosted Cisco Firepower Management Center for VMware (upgraded to 6.1) to Cisco Firepower Management Center for KVM (fresh install 6.1).
The same MAC address gave the same Classic Licenses License Key. The Licenses installed and gave us t...
Hello!
We have, to me at least, a strange problem. We have two ASA5525-X in active/standby. Only a few of the interfaces (7 out of 30) are picked up by the SFR module (the same on both units). My experience is that only traffic entering and leaving ...
Hi thereYesterday I upgraded from K9-6-0-188-0.aes to K9-7-0-116-0.aes. The controller has always been stable (86xLAP1131AG-E-K9, 2xports installed, maximum 250 users). After the upgrade it begun to reboot. Maximum uptime 5-20 minutes. Except for in ...
Hi karsten,
Thank you for the answer.
After my posting I started to think about NAT/PAT between "elsewhere" and "outside" and the answer is that it's forgotten. Should the NAT be with respect to the interface (192.168.222.0) or pool (172.16.0.0)?...
Hi,
We run 9.5(2) which is a known fixed release according to the release notes http://www.cisco.com/c/en/us/td/docs/security/asa/asa95/release/notes/asarn95.html#id_25667
But we meet the conditions for CSCut40770 (I shortened the interface-names fo...
Downgrading from 7.0.116.0 to 7.0.98.218 solved CSCtr17396. I could of course also reverted to the backup code (6.0.188.0), as stated in the workaround, but we wanted to take the move from 6 to 7.Note that only the WLC4404 was affected by the bug (CS...
