Hello!
We have noticed that ‘basic’ configuration of auto smartport on IOS 15.2 won’t apply CISCO_SWITCH_EVENT (it does on IOS 12.2(55) ).
Lab setup:
[WS-C2960X-24PSQ-L, 15.2(3)E1] int Gi0/25
|
[WS-C3560-8PC, 12.2(55)SE9] int Gi0/1
Seen from WS-C3560-8PC:
macro auto global processing
!
interface GigabitEthernet0/1
switchport trunk encapsulation dot1q
switchport mode trunk
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust cos
auto qos trust
macro description CISCO_SWITCH_EVENT
!
Seen from WS-C2960X-24PSQ-L:
macro auto global processing
!
interface GigabitEthernet0/25
no keepalive
!
#sh device classifier attached | i Gi0/25
001e.____.____ Gi0/25 Cisco-Switch cisco WS-C3560-8PC
We understand that we need some more configuration, but we haven’t managed to figure out how. Switch detection doesn’t work [WS-C2960X-24PSQ-L, 15.2(3)E1] to [WS-C2960X-24PSQ-L, 15.2(3)E1] either, or between other switches running 15.2.
(IOS 15.2 doesn’t have any problems detecting and applying auto smartport macros for the various Cisco Lightweight Access Point we have.)
Can anyone give information on this topic?
Thank you for your time.
Regards,
Erik Qvam