Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 VSS. This switch is configured with a Management VLAN called SWITCH_MANAGEMENT with this IP address 192.168.25.250 which i expect it to display in all neighbour switches when i do show cdp neighbour details.VLAN Name ...
I urgently want to replace a faulty line card WS-X6748-SFP with a new one. The switch concern is a 5609-V-E operating in Virtual Switching System mode.How long do you suggest the down time will be?
Hi there.I'm having a strange issue here. I just installed a WS-C2960S-48TS-S and connected it to the core switch WS-C6509-V-E.CDP is enabled on both devices. When i do show cdp neighbor on my WS-C6509-V-E i cannot see the WS-C2960S-48TS-S in my neig...
I Have installed LMS 4.0.1 for my client. I have also installed UTLite script on the domain controller as per instruction from cisco. When i look at the utlite.log i'm seeing message displayed below:Failed to create Tables. Transaction Rolled backFai...
While i was doing assurance on a CE router, my assurance couldn't pass as there were thousands log messages about %SYS-4-CONFIG_RESOLVE_FAILURE: System config parse from (tftp://255.255.255.255/network-confg) failed on a Cisco 2811.
You explanation ...
Hi Rene! You are spot on. I hit the issue of channel-miscong error. What i have reliaze is, is i become obssessed with deleting port-channel on interface level. For intstance C2960G(config)#int range g0/49 - 50 C2960g(config-if)#no channel-group 1an...
Hi RezaThe correct answer is this one by Edison where he said "By default, CDP will use the IP address of the first available interface with an IP.You can use the 'cdp source-interface' command to force which IP address is presented to the neighbors....
Thanks to all. You've really helped me figure out what I need to do. Probably I'll change the VLAN ID to be the least one for instance VLAN 5 (192.168.25.250-preferred) to VLAN 2 (172.16.2.2 - Not Prefered) & test the results. This will be done when ...
I first upgraded to c2960s-universalk9-mz.122-58.SE2 still my Core couldnt see the 2960 but the 2960 can see the core.I however upgraded to the latest ios c2960s-universalk9-mz.150-2.SE still same issue.I really dont know if i should log a TAC or no...
