Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have discovered a serious problem with 1142 APs after moving them to a newer controller version. They were previously ether on WISM or 3750G controllers running 7.0.240.0 or similar. I have moved them to either 2504 or 5520 controller running 8.3.1...
Since upgrading from Prime 3.1.4 to 3.1.5 I have had nothing but issues. CPU has gone crazy on the VM, No wireless site maps load at all and nothing seems to be updating properly.
Currently trying to recover from this issue.
Beware and make sure you ...
I have two 3702I ap's in close proximity. One is working fine and the other is resetting it's 5ghz radio every 30 seconds.
I'm thinking this 5ghz AP radio is faulty as I have tried different channels (widths 20mhz/40/80), set them statically, reboote...
We are having some issues with Prime 1.3. We need some advice and tuning, a backup and rebuild/restore has not addressed these issues. Specifically -System resource usage. The server uses 100% of all four 2.6/3ghz turbo CPUs every 15 mins and runs u...
I am getting errors in the logs on a Cisco WLC 3750G integrated WLC running 7.0.235.3 7925G on 1.4.1 firmwareI have set this up as per the 7925G deployment guide. Running WPA2 802.1x + CCKM Local AuthWe have a few VOIP issues at the moment so want to...
8.3.133.0 still getting a problem with 1x 3702 however I have fixed about 8x 1702 by formating flash and using recovery image.
Had about 40 APs fail in a boot loop with error like below
%CAPWAP-3-ERRORLOG: Validate Msg: msg type 4 does not supporte...
Yes it should have said 8.3.112.0. I have edited my post.
I looked at the certificate expiry issue. I disabled the age check and also tried setting the controller time back 2 years but that has made no difference.
I also get this problem with AP802...
HV revision V06 do not seem to be affected, they are upgrading OK.
My revision V02 APs are not powering on so I can't test them.
So it just seems to be V04 affected.
I should mention these are all AIR-LAP1142N-E-K9 European AP and the controllers a...
My maps issue was resolved by TAC. It was unrelated to 3.1.5 however I have show stopping issues with 3.1.5.
The maps issue was caused by a '.' instead of a null value in the database for the name of one map image. When deleting that building, Prime...
