Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am replacing a 2901 ISR that has a 'VWIC3-1MFT-T1/E1' card in it with a 4321 ISR that has a 'NIM-1MFT-T1/E1 - T1/E1 Serial Module'
The E1 card is configured for voice and is connected to an ISDN10 PRI service. On the 2901 it has the followi...
Hi there,I have an 877 router which has a DSL WAN interface. The DSL service at this site is unreliable, so the company have purchased a separate 3G router to be used as a backup. This device maintains 3G connectivity at all times and has a static IP...
Hi and thanks for your reply.
Based on your reply and the bug article, I have configured:
network-clock synchronization automaticno network-clock synchronization participate 0/1
controller E1 0/1/0 clock source line primary pri-group timeslots ...
Hi Brian
Can you elaborate on the rules you have in place? Even some screenshots with sensitive information blocked out? I can see how to create the Identity Store Sequence but I'm not sure how to implement this in the access policies and haven't bee...
HiThanks for you reply. I think the IP SLA only is needed if I was trying to do a ping or http operation or something like that to verify connectivity. I have used this in the past like below to divert traffic one way or another based on next hop ava...
Thanks Paul. I forgt mention that the 3G router is not a Cisco router unfortunately and doesn't have HSRP support, or anything like it. If it were a Cisco router that would be really good though!CheersChé
