Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are standing up a new ISE 2.2 Deployment alongside our current production 2.0.1 deployment. Aim is to test the 2.2 Deployment and then move production over to it.We have spun up a new 2.2 Standalone VM. Plan is to restore Configuration & Operation...
I have a question around enabling auto rp on the N7K switches.We currently have Auto RP enabled on a 6500 with the following setup:-ip pim bidir-enableip pim autorp listenerip pim send-rp-announce Loopback0 scope 32 group-list 40ip pim send-rp-discov...
We have successfully been managing all our WLC's via WCS. Last week one of the 6500 WiSM Controllers stopped responding to config refreshes from the WCS. When re-freshing the WCS config from the controller got the error message - failed (see logs). R...
Can the Gigaport interfaces be monitored on a 4006 (Sup 3)e.g. Gigaport10(Gi5/11,5/13,5/15,5/17)so we can tell if ports are going to get oversubscribed??
There is also a new Zero Touch deployment workflow in Early Access that allows bulk AP deployment where you can use a csv file. AP Zero Touch Deployment - Cisco Meraki Documentation
You will need to upload the Root Cert of your PKI to Access Manager so client device cert's are trusted.The session logs in Access Manager should give failure reasons
I see there is a new feature in Early Access for AP Deployment and Swap outs - not sure if that will help you AP Zero Touch Deployment - Cisco Meraki Documentation - More here - feature transferred over from Catalyst Center.The End of the "Staging Pa...
Thanks for the answer. The new ISE 2.2 deployment has different IP's and hostnames. Can you null route current production nodes directly on the the 2.2 server?
