Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - In DHCPv4, Cisco routers/switches have CLI command lines to set an Address range like "Low to High range". For example: x.x.x.1 to x.x.x.99.I couldn't find the similar CLI command lines in DHCPv6, does Cisco support it? If not, what are the op...
Or Is it "necessary" to apply priority queue outbound on an interface a phone is attached? Thanks. Is below config a common practice?!policy-map QOSclass VOICEpriority level 1!police rate percent Xpolicy-map QOSservice-policy output QOS!Interface Gx...
Hi - How to determine FP2100 in asa mode installed with anyconnect license?
Below is the show version outputs. It said AnyConnect Premium Peers : 3500
Does it mean this box is capable to handle up to 3500 anyconnect client or client-less connecti...
Hi -
How to read below qos commands in "same" Class-map?
Class Qos
bandwidth remaining X %
police cir Y% conform-action transmit exceed drop
I am reading them as follow:
#1 When there is a congestion, bandwidth remaining X % command will be u...
Thank you for your input Harold. 2nd thought, What if I configure dhcpv6 pool as /119 or /120 instead of /64? Will this work?/119 give 512 addresses, /120 gives 256 addresses.
hmmmmm.......DHCPv6 addresses keep changing once workstation is rebooted & reloaded. Run a script seems ok but this put a heavy burden on Nessus & Network administrator because the leased v6 address changes from time to time. Why don't Cisco just r...
Yes, that is the point. We plan to provide a list of workstation to Nessus that means we need to limit how many v6 address in DHCPv6 pool to begin with but the command is not available. Does it make sense?
Sorry my bad. Scanning = Nessus vulnerability scanner, Tenable scanning for vulnerability in a dual stack network environment. We don't want scanner to scan the entire /64 prefix.
