Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hej,I am in planning of LAN re-design for Head office which consists of different networks - user LAN, WAN, DMZ, Internet, Special connection, sever LANPresent traffic generation across the networks, ofcourse in near by future these values except to ...
Hello,Recently implemented a branch office LAN with dual core switches (core a and core b) all access switches connect to core a and core b.core a is root bridge with priority 0, b is as secondary root bridge with priority 4096 and rest of the switc...
While adding guest user account following errors are being generatingError(s): You must correct the following error(s) before proceeding: Error:Unknown Exception Occured. If the problem persists please send the logs to the Tech Support Cisco release ...
Hello,I am working on to design a network for small office and due to present limitations only 1 WAN router with 1 ISP is in place now, but LAN has 2 core switches with HSRP for all VLANs.At present only core1 is connected to WAN router with the stat...
Hello, I tried to depict my problem in below diagram.I'm trying to allow communication between VLANs 333 and 444.VLANs 333 and 444 Gateways are configured in Firewall using virtual interfaces.Applied the access-list at IP level from source VLAN 333 h...
Hi Shillings,Present max peak bandwidth usage based on the bandiwdth usage graphs, we would like to plan 2x fold more bandwidth capacity so that this environment survies itself upto 5 years LAN - upto 300 MbpsWAN - upto 35 MbpsInternet - upto 55 Mbps...
Thanks Shillings,CX capabilities is good to know, at present in network 5520 are present and also we are not looking for firewall upgrade in this migration.Distribution layer is quite new which is not in existance in network now, based on present tra...
Hi Peter, It worked very fine, but same is not getting effect for other 2 more access switches connected to coreA and coreB switches.They are also connected like same tengig to coreA and gig to CoreB with same configured as access switch 1.Thanks for...
Hi Matt, please consider switch names as corea and coreb, Thank youcoreb# sh run | in spannspanning-tree mode rapid-pvstspanning-tree loopguard defaultspanning-tree portfast bpduguard defaultspanning-tree extend system-idspanning-tree pathcost method...
I have same problem in WLC,1) are you using snmpv3 ? -Using SNMP modes -v2c & v32) What does this ip address relate to ? some specific device ? -Its WCSWith this problem we are unable to add guest users from WCS to WLC.Thanks in advance.
