Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two Cisco FTD 1140n (version 7.6.4) managed by a FMCv (version 7.6.5). We have the the threat, URL filtering, and Malware licenses installed and we use snort 3. We are using the most recent VDB. We block all countries but the US. Are there an...
We are trying to setup a Bosch B9512G alarm panel behind our Cisco 1140n FTDs. Internet access from our IOT subnet is working fine for the panel. The Cloud ID setup that somehow registers the panel with Bosch does not work. I have received instructio...
We have two FTD 1140ns running 7.6.2.1 (HA) managed by a FMCv running 7.6.2. We have been getting high data plane errors (82 and 83%) respectively on both. I have tried disabling SNMP and making sure I only have one Secure Connect client image loaded...
We have two FTD 1140n devices running 7.6.2.1. They are both managed by a FMCv running 7.6.2. Once the port detection/ prevention setup was made more easily accessible in version 7.4.x (I think) I jumped all over it to make our organization that much...
I have two FTD 1140ns managed by an FMCv. Both are running 7.6.2. I enabled portscannig in detection mode some time ago. I noticed quite a few of my local IP addresses scanning out to Outside (public) addresses. I know this is a nubie type of questio...
BalajiThanks for the response. An example of this is one of my hosts did a portscan when accessing google.com. I can see the Intrusion event for this. Maybe my port scan detection is misconfigured?Your thoughts?
dBu,I was de-registering through the FMC. Click on the gear icon and go to Licenses, Smart Licenses. At the top you will notice the link to go to Cisco Smart Software Manager. Just besides this should be a red X that should let you De-Register. Befor...
