Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am looking at implementing Cisco Smart Collector am wondering if I could get any feedback from people that have used or are currently using it. I am looking for Pros, Cons, and experiences.Thanks.
I am trying to implement a DAP that checks to see if personal firewall is enabled. I am a little confused on the LUA script and on what the Access/Authorization Action should be set to. Continue, Quarantine, or Terminate. My goal is if not enabled...
I have two C3KX-NM-10G on two 3750x switches. Each one of the modules have a bad port. I have the replacement and am assuming that when I put the new modules in the config from the old modules will transfer to the new ones. Am I correct on this as...
I am running into an issue with Cisco Prime Infrastructure 2.1 and a couple of our switches. When I initially added these Cisco 2960's to Prime the had connectivity and they discovered everything correctly. After a couple of days I can no longer pi...
I am assuming I would set to continue for AntiVirus check also with the script below.assert(function()for k,v in pairs(endpoint.am) doif (EVAL(v.exists, "EQ”, "true", "string")) thenreturn falseendendreturn CheckAndMsg(true, "Please install antivirus...
This was caused by interface vlan 1 not being shut down on the switch. Cisco Prime sits on vlan 1 and when it hit the switch it was trying to route back out on vlan 1 which has no ip address assigned.
I was able to do a reboot of one of the switches last night. After I did the reboot it became reachable to PI again. It doesn't make sense that I need to reboot a switch to make it reachable.
