Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,I'm trying to build an eem script on my n9k to be warn when bgp state changes but it doesn't work because of syntax and I'm a bit lost so if anyone could help that would be great :event manager applet BGPevent syslog pattern ".*%BGP-5-ADJCHANGE:.*...
hi,I would like to know how to configure tracking interface with vrrpv3 on n9k.A (master) :interface Vlan1145no shutdownip address xxxxxx/26vrrpv3 4 address-family ipv4priority 110address yyyyyyyy primary B (slave) :interface Vlan1145no shutdownip ad...
hi,I configured a firepower 2110 in asa mode.I enabled ntp on fierpower and changed timezone.Since that on ASA I can see in logs few error lines :sensord: Error updating RRD file:/var/sensord.rrd: illegal attempt to update using time xxx when last up...
hi, I have an issue to migrate from an old ASA to a new firepower in ASA mode : In my old ASA I have :access-list inside_nat0_outbound extended permit ip any object-group rfc1918nat (inside) 0 access-list inside_nat0_outboundwithobject-group network ...
hi,I have few routers (1841, 1941, 3825, 3925 and new 4k).I managed them from inside interface and to do that I have this configuration :access-list 1 permit a.b.c.dsnmp-server community xxxxx RO 1 that works well. But in scanning all udp ports from ...
thanks for your reply but I tried and it's not better :action 3.0 mail server "xxxxxx" to "xxxxxx" from "yyyyyyy" subject "Changes_BGP_DC" body "$_cli_result"% Invalid command at '^' marker.the "^" is placed under subject.. no idea whyNIco
