Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm upgrading a CM Publisher version 9.1.1.20000-5 to 9.1.2.10000-28 Installation is virtual. Initial installation was CM 9.0 , built using cucm_9.0_vm8_v1.5.ovaI get the error message "There is not enough disk space in the common partition...
I'm looking to add support for the new 7800 (specifically 7821) phones in a 9.1.1.20000-5 cluster.What are my options ?Is there a COP file or similar that can loaded ?I'd rather not upgrade the cluster or change any of the existing phone loads.Thanks...
HiI have CUCM 9.1.1.20000-5. Publisher and 1 SubscriberI'm getting alerts from RTMT that " Service operational status is DOWN. Cisco ELM DB." from the Publisher.The ELM does seem to be working ok, Product Instances are registered and synchronizing.If...
HiA few questions regarding the CUCM DB/SA cluster password entered when building a CUCM PublisherIs this the same password that is commonly referred to as the Security password used when restoring a CUCM system from backup ?What's the easist way of ...
HiWe have a CCX 7.0(2) system that was recently rebuilt after a hardware failure.The system seems to be working ok,I was checking through the System -> Control Centre -> Cisco Unified CCX Engine and noticed that the Subsystem Manager was reporting th...
Yes the cluster was rebooted.The 7800 series did not show up.I installed the 7800 firmware package not a device pack.It appears I need to upgrade the cluster to 9.1.2, then apply cmterm-devicepack9.1.2.11012-1.cop.sgn.In practice it may be possible t...
Thanks for the info.I installed the cmterm-78xx.10-1-1-9.cop.sgn file . The package files were put into the tftp server root directory. The 7800 phone does not show up as a supported device.The low end 6921 phone has gone end-of-life and will not be ...
Thanks for replying.I have a suspicion the CUCM I'm working with (7.1.5) won't allow me to do this. I couldn't see the enterprise parameter Enable Call Trace Log to enable. I'll take a closer look at this though.Andy
