Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about the ANT2524 antenna which I am using with the AP3702e. The gain for this antenna is 4 dBi in the 5 GHz band according to data in the AP3700 deployment guide. Can anyone confirm that the Asimuth RF pattern at 5 GHz in the dep...
I swapped the access points in an area from AP1252 to AP3702i and both are running the same image version, 7.6.130. Without changing any of the RRM settings or AP positions, the transmit power went up by about 10 dB in the 5 GHz band when measured us...
Can anyone please confirm if the Band Select feature (ie encourages clients to use 5GHz band) is supported on the AP3600 and AP3700 access points?Thank-you.
ISE 1.2 (on vm) creates a backup file without error. I can use the file to restore a clean ISE installation (same release) without error. However, the ISE application server process is not running. "Reload" or "App Start" do not restart the ISE p...
In order to reduce disk space usage on Prime Infrastructure I will reduce the System Data Retention period (for aggregate data) and "Background Data Collection Task" raw data retention (for non-aggregate data). If I now run 'ncs stop / ncs cleanu...
The ANT2524DB has a gain of 4 dBi in the 5GHz band. If I use this antenna with a setting of 12 dBm (ie PL=2 at chnl 36), is the actual transmitted power equal to 16 dBm which is the power setting plus the antenna gain? Thanks.
In my case, I am using 11a with 11n and 11ac disabled. In both cases, the beacon data rate is 6 Mbps. When taking power measurments, I am effectively measuring the beacon power which I believe is transmitted with one spatial stream. I assumed that...
Thank-you but I have another related question. Does Band Select detect when the 5 GHz channel is fully utilized and then stop encouraging use of the 5 GHz channel?
I found a Cisco doc which seems to say that it is the Foreign controller which contacts ISE when Central Web Auth is configured with a guest Anchor.Ref: "Only the foreign WLC contacts the ISE and redirection ACL must be present also on the foreign WL...
