Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have an issue I just can figure out, but hopefully a lot of smart people on this forum can In a lab I build a Juniper SA SSL remote access on the inside network, and SSL VPN works to this device from within the inside network.On the edge betw...
When I want to install the Nexus 1000v on a standalone ESX1 5.1 installation I get at Step 5. Confirmation the error (see attachment):Unable to retrieve deployed VM. Please check VC connectionIt's an easy setup with 4 vlans on a trunk, and the managm...
Hello,In CSM Health and performance monitor: When we are checking the IPS modules sensor healt (CPU / memory) only the graph data of the last hour is visible, when we select "last 24 hours", or " last 7 days" the "No data available" is diplayed on th...
Hello,I want to auto enroll an identity certificate on our Cisco ASA firewall based on the " Web server With Private Key" template in Windows server 2008 CA. I did all the steps nessecary on the Windows 2008 CA to configure auto-enrollment, modifi...
Hello when I try to open to CSM version 3.2 Performance monitor page from the CSM home page with an administrator account (or any account) I get the following message:You are not authorized to access the page "Critical Problems". ...
Hi Karsten. Thanks for the reply.Not all the options are feasable or wanted, because:1) Because it's a lab on a ADSL only 1 public IP address is allowed by the provider2) I tested option 2 and it worked!, but It's not really what I want, because Anyc...
This is a new installation, so no VSM is up and running yet...When using L3 the packet port group is grayed out for some reason, the managment and the control vlan are on the trunk.
The device and system is up for months now, but still only the last 1 hour is charted. Is there a setting that enables charting of monitoring data longer than 1 hour in CSM?Thanks for the help....
Hello David,Youre the best! I now know that I ran into a Microsoft bug, where there is no fix for jet.The fix is for Windows server 2008 R2, while we use the normal Windows Server 2008.Manual certificate installation was succesfull so far, I think th...
Hello David,Thanks for trying so hard to help me, thank you for that!I tried it exactly your way. Unfortunately my problem is not solved with this, I stil got after the enrollment request was send out of the router, or firewall this message on the co...
