Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, Could someone please help me on how to configure remote access VPN in Cisco 1941 ISR. Will it be fine to go forward with SSL VPN for this and if yes how to confirm if my router have the required license installed. Thanks in advance,
As of now server A is accesible from external network accessing it using the below mentioned IP and port in http browserhttp://x.x.x.x:8080For the same we have configured port forwarding (static NAT) in the cisco 1905 ISR.Also from internal network t...
Hi ,My PIX CPU load was normally 30 - 35% and suddenly it got peaked to more than 90%. I did a comparison of CPU process (taken at two intervals of time). Please see the below comparison results of CPU Process:Process NameΔ RuntimeIKE Receiver300vpnf...
Hi ,I have 5 linux and 3 Microsoft 2008 Servers, each connected to 2 Cisco 3560 Switches. The 2 Cisco 3560 switches are connected to 2 different Cisco 515e Pix. Is it possible that if i enable Port SPAN in any of the switchport and send a copy of tra...
Hi ,We are planning for fiber cabling/connectivity between our two office locations. Please see the below attached diagram.As of now the distribution switch (3750) is connected to access layer switch (2960) via SFP 1000BASE-SX port. According to the ...
Hi Paul,The above mentioned configurations worked successfully. Thanks a lot for providing the exact path.Also at the same time, it would be great if you could share the real concept of this, how it works while comparing it with the conventional NAT....
Hi Paul,Thank you for the commands. But still, will the router (Cisco 1905 ISR - IOS v15.4) be able to accept the command "ip nat enable", coz i couldn't find the same apart from the command options "ip nat outside" and "ip nat inside". Is this comma...
