Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello & Greetings.
I am using an older c1760 router. When I run the cmd, sh voice port summ, I get no output. Also, while trying to cfg pri-group timeslots, I am getting err msg. Please see the following cmds / output and help me understand. Thanks!...
Hello all & greetings. Is it correct that if I have a fully configured N7K / N5K without the FCoE and NPV features enabled and subsequently ENABLE both these 2 feaatures, I will lose all configurations? Is that NX-OS version dependent? Any work aroun...
Hello All & Greetings.I am hoping to find a link or something, which will give me a complete menu structure of CUCM 7.x. Even better would be material that would also show a screen-shot for each menu item selected. If there's a book with all this, t...
Hello & Greetings.I would like to know more about Extended VLANs (NOT how-to CONFIGURE issues, tho) ... just the concepts, when to use Ext VLANs, when not to use (esp. why not to use extended VLANs), and most of all the Why's of it. Any help / links ...
Hello All & Greetings.I am reading different VoIP books, CCM etc .. and so am getting familiar with various Protocols - H.323, MGCP, SCCP - but, what I am looking for is material that may tell or suggest which protocol would be preferable in which de...
Hello Nethelper:Greetings.Thank you so very much for the links. I hope reading and really understanding this material will help me to 'get to the bottom of it'. Again, a sincere thanks.Regards,kishan
Hello Sir:Greetings and thanks for the link.I am still pursuing the link material but have an initial question and that is, if I am working at the console (hyperterminal or telnet), would I be able to find the DHCP / DNS info, even though both DHCP /...
Hello Nadeem:Greetings and thanks for your reply to my posting.I have 2 questions, which please bear with me.1. Would you know if Using PIX v7 would help me accomplish this task, bysetting different Contexts?2. Or, if I wanted to intorduce a router b...
Hello Nadeem:Greetings and thanks for your reply-post.First, I knew I was posting my message on the Cisco forum, and thisis precisely where I wanted to post the item. I was referring to using a Radware product as a mix with the broader Cisco networki...
I will try and address the above 3 paras as 3 qs and I hope I make sense.First, 'input ur configs ...', can you please elaborate some - meanin how and what purpose, etc.Second, '.. debug ip packet ...' how / why etc.Third, no, there are no access lis...
