Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Guys,
Let me know your thoughts, I recently deployed an external wireless AP "1550" with an external Antenna "AIR-ANT2588P3M-N". The purpose of this was to provide wireless signal to 3 cameras sitting on 3 poles few feet away. The cameras are us...
Gents, We want to install 3 wireless cameras on polls in our parking lot and provide these cameras with wireless from our main building, the furthest camera is 120 meters from the main building. What is your recommendation for AP and directional or n...
Hey Guys, I have a location that has a 3750E facing the provider. The Provider is policing the traffic on their end to 900Meg. Recently the business introduced new service and we are pumping way more traffic over the link facing the provider. I am th...
Gents,I need some help understanding if it is possible to run two 1552E APs in Autonomous mode? And if there is a good document to read to help in configuring the APs in this mode. Finally, if running the 1552E in Autonomous mode is doable, do you se...
Need Some Help,I configured DSCP marking on my 3750E, however i am not seeing any hits on the correct class. Here is my config.Class Map match-any TEST Match access-group name TEST Match ip dscp ef (46) Policy Map TEST Class TEST set ...
Thanks for your reply, i will collect this info and uploaded here... few things i can answer quickly..
AP is lightweight
AP mode is Flexconnect
WLAN setting is similar to 700 other APs in the same network.
The interface setting is similar to the ot...
Hi, Thanks for your reply, the camera runs IEEE802.11b, 802.11g and 802.11n, I am hoping to get 512K stream out of it, no recording is required.There will be 4 cameras on the three posts. The first post will have a camera facing the center of the pa...
Is there is Cisco best practices for the queue-limit values? My third Q which is not the default Q is dropping packets, i am guessing that the Q is not deep enough.. What are your thoughts? This Q is used for Transactional Data. Am i overwhelming thi...
