Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So we ran out of DID's in our current range. We ordered some new ones and we will get the via our telco tomorrow. It seems they add them to the PRI on there side. My question is how do I get them into our cisico voip setup to work for our users? we a...
We are running UCS and we have some blades running vmware. We have a SAN Storage in the backend which the vm's are installed on. We are in the process of upgrading vmware from 5.0 to 5.5. The problem we ran into is all the hosts that have been upgrad...
For about the past two weeks our phone system whenever you goto the voicemail system both the menu and messages are stuttering. I cannot seem to pinpoint what is causing the problem. In a previous building we had this issue but it was due to switches...
Hey Guys. We had a vendor previously setup our IDF room with a stack of 2960S switches. Then we have a single 2960S that is not part of that stack. We needed more ports so bought an identical 2950S switch. It is not setup at all brand new in the box....
Question. we are Running the CUCMBE 8.6 and the original setup from a vendor they put the starting directory number at 1000 and ending directory number at 1200. These would auto-register as a phone was plugged in. Below is from the 'Cisco Unified CM ...
Jaime. Are you good with the voice gateway? below is the last 4 digits to the ranges I am adding. the first 3 digits are the same on all the ranges of 754. Currently the rules are as above. Is there a blanket config I can do for either all the ranges...
I cannot speak for why they are setup that way. I didnt create them. So you think I should use dial plan 10 as the example to file? I know our carrier is sending 10 digits.So would it look something likedial-peer voice 13 voipdestination-pattern 4..$...
