Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need assistance how to configure 1815w AP for POC at customer site , where i got info that i can configure mobility express and test the coverage for a customer . But i dont see an RJ45 Console port and in data sheet and software download i saw only ...
Hi i am having 2911 cme router 10.5 i have uploaded the 10.5gui.tar file in flash , enabled http , dn webedit and web authentication . Still i am not able to get the gui .Also is it possible that i am having sip phones only voice register global . wi...
Hi am using CUCM 10 and h323 gateway 3 PRI .
I found that when i dial to mobile phone and just disconnect the call from the mobile , still the cisco phone rings .
I informed that service provider is not sending the RX disconnect (disconnect signal )...
Hi i have 20 access points and wlc controller with 15 ap supported .I got 5 ap license but am not able to upload . Temproray i have enabled evaluation license which is valid 12 weeks . but when i tried to upload the liecense its giving me error .Can ...
Hi i have got a customer where they have existing WS-C4506-E 6 where they have few connections .Now they want to put two X2-10GB-SR the other ports where using CVR-X2-SFP .I have a doubt that if CVR-X2-SFP is using in first port then can i use...
Hi I have seen steps to convert it for mobility express version from capwap . but i see only those are for 1850 2800 . In the cisco software download for mobility express i cannot see for 1815w mobility express . Do you have any idea whether cisco ai...
Hi Richard Thanks for the feedback.i jut want to confirm1>> If i use 1st port CVR-X2-SFP then can i use the 2 port X2-10GB-SR or i should you in 3rd port .2>>if first 4 ports are using CVR-X2-SFP then the remaining 2 ports can i use X2-10GB-SRthe li...
Dear Scott Thanks a lot.....Just had a small doubt the as customer wants to keep the second WLC in one another branch its in another network .So if in that senario of i upgrade to 7.3 both WLC the all configuration will Replecate atumoatically when...
