Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we're looking to replace a couple VG224s with some bad analog ports with the newer VG310 platform. I have a couple questions for anyone who has used the VG310 as a replacement for the VG224:
1) when ordering the unit, do you need to also ord...
I see that release 7.1.1-037 is available for the WSA. is there anywhere I can find the release notes/resolved & open caveats for this upgrade? As seems typical, on a bleeding edge release it's near impossible to find any documentation on cisco's w...
Hello, I'm looking to see if there is any documentation or configuration examples on how one would go about configuring a Cisco 112-FXS voice gateway with CUCM 8.0.3.10000-8.the data sheet that talks about the VG202,VG204,VG224 and the C3945-112FXS/K...
I never was able to find any documentation at the time, that helped me configure the 112-FXS on CUCM 8.0.3I had to wing it, but I was able to get it configured properly. Here's the quick and dirty on how to set up the 112-FXS on CUCM 8.0.3 as either...
Eric,Thanks again for your response, but I'm afraid we're running around in circles here..7.1.1-037 is available for upgrade on our Ironport (our ironport is currently running 7.1.1-033). It makes sense to me that 7.1.1-037 is a replacement for 7.1...
Eric, thanks for the reply and the link to the general release notes for the WSA.Unfortunately, the link you provided does not include the release notes (and/or resolved/open caveats) for 7.1.1-037 (or 7.1.1-033 for that matter).My original question ...