Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there.Subject above has reached its EOL a long time ago already. Can you please suggest a replacement model? I am not yet quite familiar with this product and also doing some research. I hope you can help me along. I have attached the specificatio...
Hi everyone.Is it possible to filter and monitor a user's device via it's mac-add?For example, I want to filter facebook and youtube in our company. I also want to have a status report regarding which mac-addresses are attempting to go into the sites...
Hello there.I'm trying to setup an IPsec VPN tunnel between two routers in GNS3 via Cisco Config Prof for my studies.I already did some research. Upon checking some tutorials, rip,ospf, or eigrp is always configured first between the routers before p...
Hello there.I was told that a controller-based AP, specifically the Aironet 1600 (AIR-CAP) can be converted to a stand alone AP via IOS update.Can someone please provide me the steps on how to do the update mentioned above upon purchase of the Access...
Hello there.I was just wondering why the switch fabric in switches are so high (90 Gbps for 2960s, 160 Gbps for 3750x).Considering a contact center network having the following requirements:Total IP Call Traffic: 31.552 Mbps (Assuming G.729 and 290 s...
Hi. What IP is the host trying to reach? If the destination IP falls within any of the denied address ranges in ACL 150, then you'll have no policy matches and the switch will do normal forwarding. Please do another ping and provide the following: - ...
Hi Mike.Configured static routing between two sites. Worked just fine for testing.Just to clarify things out, does R1 really need to know the routes behind R2 and vice versa to successfully create a tunnel?Regards,Kev
.png "Mike Williams"){kind=avatar}
