Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a site-to-site vpn between two ASA 5505 firewalls. The tunnel establishes, but traffic icmp does not pass. Actually ping has worked twice, but just randomly. I need it to work consistently. I have attached both configurations as wel...
I am trying to setup a Cisco ACS 5.2 for both login and enable authentication to asa 5505s, 5510s, and catalyst switches. I am testing with an ASA 5505. The initial authentication to the firewall works, but when I try to enter privileged exec mode us...
That helps a lot. It's very likely that if the DSL and IP were the only things that were changed, then it's related to one of those. I assume you have verified your peer addresses are correct on both ends. I have a couple questions:1. Are the DSL mod...
Do you have a router behind the ASA that could have bad routes in it? Are you pinging from the ASA itself or from a device behind it? Can you add the "management-access inside" command and try to ping from the asa using the "ping inside x.x.x.x" comm...
I would look at your phase 2 transform set and verify that the access-list on the ASA matches the (reverse of) the matched subnets on the RV router. If you have multiple subnets on either side that you are matching, the RV will need a separate phase ...
.png "Mike Williams"){kind=avatar}
