Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently moving from ASA 5525 to Firepower 2140 with FMC1000. I am in the process of moving object. I have over 3K objects and I would prefer not to do them all one-by-one. I cannot use the migration method provided by Cisco. Is there a CLI opt...
I'm currently converting from ASA 5525 to FirePower 2140 w/FMC. As I am auditing my current ASA I see there are lots of No-nat rules with hitcnt=0 these look to be at (0) for a long period of time. I wanted to understand does the NO_NAT rules actuall...
Hello -- I am trying to determine if my psckets are being marked withe correct DSCP value on a 6513 Sup2t. I have put all the output below. My primary question is the traffic coming from port 2/3/23 being marked with DSCP 46? I am using MS Lync and t...
I just installed a new 6800x with 3 external FEX 6800i and they're currently in burn-in status nothing attached to them. The sho process output is: CPU utilization for five seconds: 30%/0%; one minute: 32%; five minutes: 32% PID Runtime(ms) Invoked...
I am trying to configure static route redistribution on Nexus 5K using prefix list. I want to redistribute the 0.0.0.0/0 route into EIGRP and well and a host route. Is there an example someone can point me to.
I just installed the 6800x code: c6880x-adventerprisek9-mz.SPA.151-2.SY3.bin And I have high utilization:CORSHE1-LAMR-SW1-G1E#sho processes cpu history 3333333333333322222333332222233333222233333333333333333333 444477777444446666655555666668888...
Apparently this is a known bug with Cisco CSCul08799IPDT: nmsp prevents converting the port from access to trunkCSCul08799DescriptionSymptom:"nmsp enable" doesn't allow the port to be converted from access to trunk. Even when "nmsp attachment suppres...
I have access to my terminal server I have connected to it via console cable. I ran the "show line" command after trying to attach to the router and I also added a sw1 on 2009. See output below:T1#sho line Tty Typ Tx/Rx A Modem Roty AccO Ac...
R1 is powered and I can console to it directly using secureCRT and the cisco provided cables, nothing on the device preventing connectivity. Can't do a show line as I'm away from the equipment. I can do that later this evening. I have looked at the ...
