Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,
Is it possible to use Cisco DP04QSDD-HE0 optics between two NCS 540 routers without using OLS (Mux/Demux or Amplifiers) for short (<80–100 km), clean dark fiber link ... i just want to use a single wavelength on this span.
Best Regards,
M.Jal...
I'm having an ASA/FTD configured with Public IP address on Outside Interface for ISP1 pointing to a nexthop router which is configured with another Public IP address of the same ISP1 subnet, we have a new requirement to add another ISP2 . and move ...
Hello, Is it possible to use load balancers in a setup with multiple AMP VPC servers , the target is to have multiple AMP servers serving AMP connectors in the same time to achieve some high availability since there is no HA capability built into pri...
Hello, I have ISE 2.7 , as part of RBAC testing ; I was trying to apply data access permissions on specific NDG's to restricts access for specific administrators to only view certain RADIUS Live logs on specific network devices belonging to specific ...
Hello, We have an issue on DMVPN setup on which all traffic is working normally between Hub and spokes except for some specific web application, the login to application page is working also fine and page is accessible but when trying to download som...
Thanks Marce,
I read that note , and thought i should make sure will it operate normally without pre-filtering a specific channel using (Mux/Demux) , since i will need to configure the router port on which i will plug the "DP04QSDD-HE0" for a specifi...
@MHM Cisco World why i can't NAT both ISP subnets on ASA outside interface and use "arp permit-nonconnected" ...
for example:
nat (any,outside) source static {ASA-Outside-private-IP} {ISP1-Public-IP} destination static {Peer-X} {Peer-X}
and even pub...
@Flavio Miranda right , All VPN's are peering currently with a public IP address on ASA Outside interface ...
I was thinking of the below :
- Change the current Outside Interface IP address to a new private ip (say x.x.x.1).
- Change the current I...
