Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two switches and I'm trying to get a basic network working, for some reason ESW2 switch has configured as a layer 2 router. With a default route is not routing traffic properly to the layer 3 switch 3.
The issue is between the layer 2 and the ...
Hi All,
I have spend a considerable amount of time trying to get me head around the QOS marking between the 3750 and the 3850. Basically please look at the configuration below, I have attempted to map the configurations from my 3750 to my 3850 but t...
Hi All, Really need some assistance I have a Cisco ASR 9010 which I've recently installed. Its reasons Cisco XR 4.3.2 which I believe is the standard XR image. I have a SIP 700 installed along with an STM-16 SPA (4-Port) OC48 SPA. I have brought up...
ESW2#show cdp neighborsCapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port IDESW1 ...
ESW1# show cdp neighborsCapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port IDR1 ...
