Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm trying to upgrade a 6807-XL with 2x SUP 6T (sso redundancy mode) with ISSU procedure.
The running version is s6t64-adventerprisek9-mz.SPA.153-1.SY2.bin and I'd like to upgrade to 155-1.SY1.
I issued the command
"issu loadversion 4 bootd...
Hello,
have to configure LLQ+CBWFQ to prioritize VoIP traffic and Guarantee BW to Signalling traffic and Best effort for all other traffic.
I have a CISCO 2901 ver 15.1.4 and the output interface is a subinterface of the GigabitEthernet0/1 interfac...
Hello,from feature navigator look like REP is supported from 15.0.(2).As I try on a ws-c2960x-48TS-L there is no rep command possible. Where I'M wrong ?
Hello,I have 2 router that build up 3x VPN (ikev2/IPsec) using tunnel on 3 different vrfs.Normally this tunnels work fine without problem. somethimes after an ip disconnection some of those tunnels doesn't negotiate ikev2 correctly. This happends ran...
I'm asking myself the same question, how SPAN can load the CPU, in particular if you monitor more 10G port on a 4500. Do you have a feedback about issue above ?
related to "Output drops due to QoS on 2960/3560/3750 switches" here above you can increase max buffer size (borrowed from common popl) and consequently threshold1 and threshold2 to 3100%. what about threshold3 that is still implicit to 100%. Does t...
Hello, thank's for reply. The idea to untrust inter-switch link is because there is situation where you can't manage the uplink switch or as first step of a migration fase to be sure that only traffic from QoS configured switches is tagged (DSCP & C...
hi againAre you running this under the Cisco 1000V or the VMWare switch? I'm running it under Nexus 1000VWhen you are running in multicast mode are you then using SessionDirectory also ? Yesif so do you then also observe a short disconnect when loggi...
Finally to make it working I confiured the NLB in multicast mode and activated the igmp snooping. The drawback is that you have to configure arp resolution for the multicast MAC on the Router on the subnet.
