Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco Catalyst 4500E Supervisor Engine 7-E and configured an EEM Script to monitor the dual core CPU Utilization through PRTG Network Monitor. event manager applet dualcore authorization bypassevent timer cron cron-entry "* * * * 0-6"!act...
Hi,I have 1 NX5K & 1 NX2K (FEX) and configured PIM on them -Release 5.2(1)N1(1).I configured on the NX2K's ports the ip igmp join-group command to statically bind a multicast group to an interface. The multicast PIM works fine but when I try to remov...
Hi,An unexpected reset on the active supervisor caused a switchover between the active and standby supervisor engines 32 / MSFC 2A on cisco WS-C6509-E, Cisco IOS Software -s3223_rp Software (s3223_rp-IPSERVICESK9_WAN-M), Version 12.2(33)SXH4.I use...
I configured the tcl script in a WS-C4506 and I received constantly this log:%HA_EM-6-LOG: tm_monitor_cpu.tcl: can't read "c0cpu5sec": no such variable %HA_EM-6-LOG: tm_monitor_cpu.tcl: while executing ...
I did it but I received some errors -the snmp community it is ok & the %HA_EM-7-FMFD_SNMP_ERRCODE: fh_fd_snmp_errcode: Error status: 6 NO_ACCESS_ERROR: 1 appeared again.C:\>snmpset -c tester -v 2c 10.10.10.254 1.3.6.1.2.1.90.1.2.1.1.9.5.99.105.115.9...
Yes, It is a valid SNMP RW community string but I can not monitor the dual core and I received this error: %HA_EM-7-FMFD_SNMP_ERRCODE: fh_fd_snmp_errcode: Error status: 6 NO_ACCESS_ERROR: 1.
