Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am running 2 ACS servers on the SE platform running 4.0(1) Build 42. On one server everything works fine, but on the other server I get this:TCP Ports Opened49 opened2000-2003 opened1075 opened49 opened2000-2003 opened1075 openedUDP Ports Opene...
Hi I have an annoyance on my 806 router. When I reboot, my Dial1 interface seems to take 20 to 40 seconds to come up. I do a "debug dial" and I get : Di1 DDR: Cannot place call, no dialer string set. After about 40 seconds my d1 interface finally ...
I think the OP meant that the trunk was passing other unrelated vlans other than the one they wanted to be a monitor destination.
At least that is what I was trying to do. I trunk to my mac mini and pass different vlans to different virtual hosts. ...
So the answer seems to be "yes, you can use a trunk port as a destination." However the answer is also, "no you cannot use a trunk port as a destination" if you actually want to use the trunked port for anything else besides monitoring.
I am gonna take a swag at this and recommend you lower your MTU sizes on the PC's at the 831 end and try your testing again. I recommend an MTU size of 1300 or less. http://www.dslreports.com/drtcp is a good tool to easily change MTU size.Hopefull...
I would connect a DSL router to the modems at both sites and run RIP on both DSL routers and both 2650 routers. If you only have two sites RIP wont be a problem. I would let both DSL routers (like a linksys befsr41 or something cheap like that) do ...
