Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is a video from the live webcast on BGP Multi-homing with Cisco Support Engineer and CCIE Manigandan Ganesan. This webcast provides an overview of BGP Multihoming and gives advice on how to troubleshoot common BGP problems like peering and high...
IntroductionBGP Multi-homingRelated Information Introduction Manigandan Ganesan is a Customer Support Engineer at the Cisco Technical Assistance Center Routing team in India. He also holds the CCIE certification. This document contains the answers...
Hi Varun, Could you eloborate more on the issue that arises with the ASA's ?Just to understand, what is the limitation with running the same OSPF process between the routers and the FW ?Thanks,Mani
Hi Tom,So the only change you made is an inbound filter to permit a default and a few more.It could be split horizon where a few of the local connected subnets were learned on the interface accidentally and hence these were not advertised out, even t...
Hi Johnny,The feature for forwarding a range of UDP ports is not supported on Cisco IOS. An enhancement request has been filed for this already.You could try this workaround below; however it does not work all the time I try.ip nat inside source sta...
Hi Joshua,1. I can think of two options.a. You can run HSRP / GLBP on the edge routers and track the WAN / BGP route for failover. Default routes on all the internal devices can point to the virtual ip address of the group.b. You can run IGP and inje...
The reason is ASR router is a hardware switching based platform compared to other routerslike 7200,7300, 3800 etc..which are software switching based platforms.For hardware switched packets, ACL counters will not report any value. If we need to see t...
