Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I think I must be missing something simple here, but I can't seem to get this to work:
username admin password 0 peter priv 15
aaa new-model
aaa authentication login default local
When I try to telnet into the switch:
User Access Verificat...
Hi all, looking for opinions here
We have a bunch of 3750-X switch stacks running 12.2.55-SE9(MD), and I was wondering whether anyone has experienced any problems with the 15.2.4E1(ED) firmware ?
The reason for the upgrade is that we are trying o...
Hi all,I get an unusual error message on boot, on a stack of two 3750-48 POE switches:CFGMGR-4-SLAVE_WRITING_STARTUP_CFG: only master can do that. I've never noticed this before, and I don't know if it's my imagination, but the stack seems to be resp...
Hi all,We have just installed Prime LMS 4.2.3 (about a week ago), and it is pretty much working as expected, except for one thing - I cannot get any data back from the reclaim ports report.I have tried both the Ports Up and Ports Down options, and ha...
Has anyone seen this problem ? We swapped over a network printer the other day, and the new device could not be seen on the network until we changed its IP address - even if we were directly telnetted into the switch it was attached to ! Maybe this i...
Hi Ash,
That certainly stopped the link flap, but I would like to have a faster speed than 10mbits/sec on the Vivi due to wanting to stream HD video to the device.
So I contacted Vivi support about this issue, and they pointed me to this bug: CSC...
Thanks guys, I'm glad it was a simple mistake on my part - I think I have entered it the other way around on the ASA devices I've been working on recently.
I guess that the only reason that I did not get an error was that spaces are acceptable ch...
Thanks guys, I'm glad it was a simple mistake on my part - I think I have entered it the other way around on the ASA devices I've been working on recently.
I guess that the only reason that I did not get an error was that spaces are acceptable charac...
