Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a Edge 95MXP with multisite option for 4 sites conference via Internet (not WAN). Now I want to use Jabber Video. As I know, VCS-C and VCS-E are required. But my scenario is a little different from deployment guide: internal network is ...
Hi all,I have 2 video conferencing systems including Cisco SX20 TC6.0.0.876266 (near end) and Polycom VSX 7000a version 8.5.3 (far end). Dual Display option is activated on SX20 and I also set parameters in SX20 as follows:Layout -> Monitors: DualOut...
Hi,Does anyone try to connect Wireless microphone to the second microphone input (Cisco Table Mic 20 microphone is connected to the first microphone input)? Is this connection OK if I want to use both 2 micphone types?
Hi everybody,I implement two Cisco SX20 units at two sites. When trying to place call between two units, it's unstable. Particularly, sometimes the call is connected, sometimes it's not connected although ping, tracert are Ok. It's very strange. I'm ...
Hi Jens,I also know that VCS-E starter pack is the best choice in my case but the problem is my company has bought VCS-C and VCS-E before so I have to use these devices.
Thanks for your reply.I connected wireless microphone to SX20 mic input and sound is quite good. But when I connected both Cisco Table Mic 20 and wireless microphone to SX20 codec, only Cisco Table Mic 20 is available. Do I have to set any parameters...
Hi Dharmesh,I put the private IP address to DMZ already, also open ports as the list above. But sometimes I can place call between two SX20, after few minutes I can't. I don't know why's that?
