Hi, can not set this controller as a pri-group or ds0-group for CCS or CAS signaling.In controller, only channel-group is availableCME_ROUTER(config-controller)#? Controller configuration commands: cablelength Specify the cable length for a DS1 l...
Hi,Im a tring to setup the dial-peers on both my CME to send PSTN traffic from CME A who has the IP phones, and CME B who has the POTS.How can I setup dial-peer in A and B ?Thank you
Thanks to all for the help.I found a Cisco NM-HDV Genuine for $20 on ebay.Does the NM-HDV comes with enough DSP to operate a LAB ? or do I need to buy one PVDM module on top of this ?Of course I will need to remove the MN-2V / FXO FXS for the T1 and...
Thanks for the links and info. The NM-2V card is for my FSX and FSO. (1/1) - they work OKVWIC-1MFT-T1 is connected to a diffetent stand alone slot. (1/0)Do you mean I need to add a DSP card inside the router ? because there is no room on the router f...
This is for a CCNA VOICE LAB, I dont have another ISR. I have a 2811 but no T1 card for it.DSP should not prevent me from configuring the pri-group or ds0-group ? I might be missing some DSP hardware, but Cisco documentation confirms this card is sup...
There it is: CME_ROUTER#sh diagSlot 0: C2610XM 1FE Mainboard Port adapter, 3 ports Port adapter is analyzed Port adapter insertion time unknown EEPROM contents at hardware discovery: Hardware Revision : 1.0 ...
