Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently in the phase of deploying new access points at a remote site. The site has had AP 3500s till now. It has no issues with clients connecting over a radius enabled SSID. Both new and old access points are connected to WS3650-24PD switch...
Continuation of another issue that is being researched by our provider, albeit snail pace
Transferring data sets is extremely slow, <1M on a 500M circuit.
This is not happening to ALL sites, 3 transfers at expected rates, the other 9 are dismal.
A...
Getting some poor iperf results as shown below. Only in one direction. Doesn't matter what network segment I target in that site.
C:\Temp>iperf.exe -c x.x.64.x -d------------------------------------------------------------Server listening on TCP port...
I have a SME which has horrific connectivity, 450ms+ latency. We have not tried but been told putting an AP up there to connect back to our local 5508 WLC will cause more grief than good. What options are recommended for controller-less APs for this ...
Our NMS is unable to ping some edge switches, however able to ping others. There are no static routes on the sw, when I execute 'sh ip route' three addresses come back plus def gw..Host Gateway Last Use Total Uses Interfac...
Hi Rasika, This is Jeet, Hope you remember me we met at Cisco Live last month. Anyway I had a query regarding clients connecting on 802.11a even though the radio policy is set to 802.11b/g only on the WLC policy. Screenshots attached. I am currently ...
Still testing but I think we may have found some resolution with regards to this issue. Clients can connect to the SSID okay now.
After reading a bit about the switch port configuration. I disabled the native vlan tagging on the switch which allo...
I was able to fix this after I applied the flow monitor to particular interface to monitor the traffic (inbound/outbound). Eg. configuration below on a couple of switch ports.
interface GigabitEthernet1/0/1 switchport access vlan xxx switchport mode...