Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I have a customer insisting on a manual failover (2 internet links) using a Cisco 1941 using only 1 WAN port, ie Gigabit Ethernet 0/1 (GE0/0 = LAN)Before he purchases an extra EHWIC for the 1941 to give him another L3 port he wants to ma...
Hi,I'd currently experimenting with IOS based IPS and want to see if it's relevant for my customer. Im configuring it through Cisco Configuration Professional version 2.6 and using downloaded signature sigv5-SDM-S724.zip and the public key loaded as ...
The setup is a S2S VPN with failover to 3G HWIC in a Cisco 1941 however the IPSEC tunnel needs to remain up through 3G if ADSL fails.The failover works ok, however when plugging ADSL back in, the - "sh crypto session" shows both dialer 0, and dialer ...
Hi,I'm having problems with the following config. I cannot work out how I am supposed to perform the natting.The BGP route is active as the default route when I type "sh ip route", and if BGP route is lost the floating static (default) route takes i...
Hi all,I have a big bad DMVPN (Hub and 2 spokes) problem which I can't quite sort out.There are 3 sites - A (hub), B and C - (C is not an issue however as it uses it's own link to get out to the internet)All users from Site B need to access all traff...
I've just had this same issue from exactly the same IP. Unbelieveable. 6 vty 4 root idle 00:01:36 144.0.0.51 To gain root access to the router must be an exploit to a known vulnerability. as there definitely isn't any 'root'...
Thanks for the quick feedback! I was thinking along those line but unsure if the Secondary IP address on Gig0/1 was a valid option. I will try this shortly
Ok, I can see you'll need more- interface Vlan102 description Floor 2 VLAN ip address 192.168.2.1 255.255.255.0ip nat inside!interface Vlan103 description Floor 3 VLAN ip address 192.168.3.1 255.255.255.0ip nat inside then remove this-access-list 5 p...
sorry, I meant I can see the "IP NAT OUTSIDE" statement on your outside interface, however I see no "IP NAT INSIDE" statement on your inside interface. ie Gig0/1
