Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,Let me provide some information regarding to my question.! Dial-peer configuration:dial-peer voice 10 voip destination-pattern 2002 session protocol sipv2 session target ipv4:172.16.16.1!Calling from C7962(TypeB/SCCP:DN5001 (redialing,...
Hello everybody,
I've found a list of functions for uck9:
"Offers the UC Features found in IPVoice IOS image on ISR 1800,2800 and 3800 e.g. TDM/PSTN Gateway, Video Gateway[H320/324],Voice Conferencing, Codec Transcoding, RSVP Agent (voice), FAX T.37...
Hello everyone,I have a question about selection of outgoing dial-peer and strange behavior. This is my current config(CME=8.6):R1#sh dial-peer voice summary dial-peer hunt 0 AD PRE PASS O...
Hello everyone,
R1#sh dial-peer voice summary dial-peer hunt 0 AD PRE PASS OUT TAG TYPE MIN OPER PREFIX DEST-PATTERN FER THRU SESS-TARGET STAT PORT KEEPALIVE20001 pots ...
Hello everybody,Please check how I can fix the situation, thank you in advance.On a router I added the commands:ccm-manager config server 1.1.1.1ccm-manager configThe router pull from TFTP(CUCMv.8.) the config BUT only after reboot of the router. So...
Hi Deepak,
Thank you for your reply. It is clear about UCK9, but could you tell me something about Collaboration Professional Suite License (not about permanent or RTU). What is the purpose? What is the difference from UCK9?
Thank you in advance.
...
Good day Jaime, thank you for your message.Let me give you more information.
R1#sh run | sec dial-peerdial-peer voice 5 voip destination-pattern 2T session protocol sipv2 session target ipv4:192.168.2.2dial-peer voice 15 voip destination-pattern 2......
Good day Deepak,
thank you for you reply.
<< when you dial 2001XXXXX soon as 2001 is matched against 2... pattern it is taking that dial-peer.
I would agree with you, if I had two patterns: 2... and 2........ In my case I have one pattern: 2T, so I...
Hello Brandon, everyone,
Thank you very much for your comment.
I have checked the situation again and I was wrong - both dial-peers are used.
Now I have other questions, but it will be not correct to keep it under this discussion.
So I am going to op...
