Hello everyone,
Let me provide some information regarding to my question.
! Dial-peer configuration:
dial-peer voice 10 voip
destination-pattern 2002
session protocol sipv2
session target ipv4:172.16.16.1
!
Calling from C7962(TypeB/SCCP:DN5001 (redialing, from the call-list or onhook&dial: EN BLOC) to DN2002.
I have no doubts - DN5001 is sending it as Enbloc, not on digit-by-digit basis.
Checked by - debug ephone message: SkinnyMessageID = StationEnblocCallMessageID(calledParty=2002)
At the same time, Dial-peer hunting is performing based on digit-by-digit.
I can prove it by - debug voip dialpeer inout:
Match Rule=DP_MATCH_DEST; Called Number=2
Match Rule=DP_MATCH_DEST; Called Number=20
Match Rule=DP_MATCH_DEST; Called Number=200
Match Rule=DP_MATCH_DEST; Called Number=2002
Result=SUCCESS(0)
List of Matched Outgoing Dial-peer(s):
1: Dial-peer Tag=10
Can you confirm that Dial-peer selection for SCCP phones, will be always done based on digit-by-digit analysis?
Always, I mean despite on how the digits were collected (enbloc or digit-by-digit), firmware, IOS version or phone model.
Please give me more information about enbloc with SCCP, thank you in advance.
--
Have a nice day,
Dmitry