I've read through the CCO info on ATM OAM PVC management and although the sample configurations are usefull, there is a lack of information on configuring LS1010s for oam pass-through...I have 2 routers connected together through 2 x LS1010srouter <-...

I'm trying to keep traffic separate, and need to redistribute a static pointing to null0 into eigrp.This is causing a mass (100+ pps) of eigrp traffic between the 6 routers involved and a number of Stuck-in-Actives....If I take the null0 route out, e...

After a CatOS and MSFC2 upgrade which appeared to have been Ok, recieved a message from the catalyst saying it had powered down module 5 (FlexWan card).Any attempts to repower / reseat / reset the module and catalyst now result in the FlexWan module ...

Hi. Looking to nat DNS messages flowing across a PIX.Seen the "alias" command, but this seems to be for DNS servers on the outside only: (ie. DNS reply is NATed on a transition from a Low -> High interface)whereas I have a DNS server on the inside, w...

Does anyone know of a CCO page detailing the Skinny message id's and their meaning.Specifically, getting a message id = 0x2A from an MTP port to the CCMMany thanks