Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I would like to copy my 1841 ISR config to my new 4321 ISR. We still use the VPN client 5.x for remote users.
Can I simply save my Config on 1841 and copy/tftp it to 4321? Does anybody see any issues with that. Of course the ports need to be...
I am trying to configure this wonderful appliance to work with my Wave Crest HTTP proxy. 192.168.20.6 is proxy server IP.Does any have the correct code for this ver IOS? Any ideas? This does not workinterface Vlan1ip address 192.168.20.1 255.255.255....
I have a bonded T1 3 MB circuit and need to add QOS to allow guaranteed 1.5 MB throughput to below IPSEC tunnel destination 10.10.22.0. Then all other internet traffic fifo. We are using ISO 7.2(2) and ASDM 5.2(2)What's the best way to configure QOS...
I would like to get some thoughts on best practice regarding joining 2 different networks in the same building. 2 different companys 2 different networks, we are merging. Once networks are joined we will trust the windows domains. Both networks are ...
We just upgraded our CUCM from 4.x to 9.0. Thold IP dialer that worked with 4.x does not work with 9.0We just need a tool that will allow users to click on Outlook contact and dial the number with CUCM 9.0We used to use Intelligent Outlook dialer by ...
Hi Rick,I corrected the above mistakes still no tunnel built. I have run debug and only get debug info when a PC is attached? I get no debug errors when pinging from pix console. I have reset keys to make sure thats not issue. What else could it be? ...
I added "Group 2" to both routers nothing somes up under. sh crypto isakmp saI also rebooted routers. I removed group 2 and added Group1. Still no VPN activity via sh crypto isakmp saCould this be a IOS VPN licensing caveot? I think both routers are...
As you can see I full ping from 192.168.1.1 to 192.168.2.1 and visa versa. Why is the tunnel not coming up? CCC#ping 192.168.2.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.2.1, timeout is 2 seconds:!!!!!Success rate is 10...
Yes its disabled by default it seems. I did a erase Nvram:. The wierd thing is I used the built in GUI and configured it for use with cable modem. That must really drive a lot of people nuts!
